Watch the webinar recording of SimSolid - Analysing Bolted Connections.

This session will demonstrate how SimSolid automatically creates bolted connections making the whole process of analysing bolted assemblies a pleasure

What you will learn 

On many occasions during my Inventor Stress and Inventor Nastran training courses I have been asked ‘Can we use bolted connections already created in Inventor?’ My answer has always been unfortunately NO.  Inventor Nastran uses the classical method by representing the bolt with a beam element. However, setting up bolted connections within Inventor Nastran relies on selecting faces that are in contact with the bolt head and nut. Meaning the need to split faces within Inventor and this process is very time consuming. This normally in extreme cases yields to just using the bonded contact between the plates normally held by bolts.

Fill in the form to watch the recording

The webinar lasts approximately 30 minutes